A 24-GHz 3.9-dB NF low-noise amplifier using 0.18 /spl mu/m CMOS technology

A 24-GHz low-noise amplifier (LNA) was designed and fabricated in a standard 0.18-/spl mu/m CMOS technology. The LNA chip achieves a peak gain of 13.1 dB at 24 GHz and a minimum noise figure of 3.9 dB at 24.3 GHz. The supply voltage and supply current are 1 V and 14 mA, respectively. To the author's knowledge, this LNA demonstrates the lowest noise figure among the reported LNAs in standard CMOS processes above 20 GHz.     

Improved shape evolution of copper interconnects prepared by jet-stream etching

In the preparation of copper interconnects in the conductor pattern of a printed circuit board (PCB), wet etching processes are commonly adopted for creating patterns of high-density interconnects. Currently available techniques of immersion and spray etching could lead to poorly shaped wires due to complex flow fields or the disturbing puddling effect. A modified technique of arrayed jet-stream etching was developed in this work, aiming at producing well-defined copper interconnects on a PCB in a significantly shorter time. The results were appealing in that copper interconnects of 35/140 μm (thickness/width) exhibiting etching factors of greater than 6 were obtained in 20 s, much better than the conventional ones with etching factors of 3 to 5 and etching times of at least 2 min. In addition, uniformly etched copper interconnects with less than 20 μm undercuts were observed on one etching line. One additional point to note is that no banking agents or inhibitors as commonly seen in conventional etching techniques were needed in this new processing method.     

Accelerated wear testing with a microfabricated surface to evaluate the lubrication ability of biomolecules on polyethylene

Wear of ultrahigh‐molecular‐weight polyethylene (UHMWPE) and wear‐particle‐induced osteolysis and bone resorption are the major factors causing the failure of total joint replacements. It is feasible to improve the lubrication and reduce the wear of artificial joints. We need further understanding of the lubrication mechanism of the synovial fluid. The objective of this study is to evaluate the lubricating ability of three major components in the synovial fluid: albumin, globulin, and phospholipids. An accelerated wear testing procedure in which UHMWPE is rubbed against a microfabricated surface with controlled asperities has been developed to evaluate the lubrication behavior. An analysis of the wear particle dimensions and wear amount of the tests has provided insights for comparing their lubrication performance. It is concluded that the presence of biomolecules at the articulating interface may reduce friction. A higher concentration of a biological lubricant leads to a decrease in the wear particle width. In addition, in combination with the wear results and mechanical analysis, the roles of individual biomolecules contributing to friction and wear at the articulating interface are discussed. These results can help us to identify the role of the biomolecules in the boundary lubrication of artificial joints, and further development of lubricating additives for artificial joints may be feasible. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Estimation and hypothesis testing of treatment effects in animal reproductive toxicology studies

Healy (1) and Dempster et al. (8) proposed statistical methods to evaluate the treatment effects in animal reproductive toxicology research. Both methods assume homogeneous variance for the dams and the pups, respectively, in all the treatment groups. In this paper, via mixed effect modeling, we propose a method to estimate the treatment effects allowing heterogeneous variances for the dams and the pups, respectively, in different treatment groups. Covariates will also be included in the model. A procedure to test the fixed effects is also discussed. An example from an animal reproductive toxicological study is used to illustrate the procedures.     

Feasibility of adding a personal communications network to anexisting fixed-service microwave system

This paper examines the feasibility of adding a personal communication network (PCN) to a frequency band which is already allocated to fixed-service microwave systems. To achieve this goal, spread spectrum techniques are used to spread narrowband PCN signals into wideband. The forward and reverse link performance of PCN users under the influence of the microwave system and the influence of PCN users on the microwave system are both examined. It is proven that spectrum sharing between the PCN network and microwave systems is indeed feasible. Although our analysis is done based upon the consideration of only one microwave system, it can be easily extended to allow the appearance of two or more microwave systems     

Percutaneous balloon pericardiotomy for patients with recurrent pericardial effusion: using a novel double-balloon technique with one long and one short balloon

Percutaneous balloon pericardiotomy is effective and less invasive for the treatment of recurrent pericardial effusion. This study suggests that the double-balloon method with 1 longer and 1 shorter balloon is the procedure of choice for percutaneous balloon pericardiotomy.     

Multicluster,mobile, multimedia radio network

A multi-cluster, multi-hop packet radio network architecture for wireless adaptive mobile information systems is presented. The proposed network supports multimedia traffic and relies on both time division and code division access schemes. This radio network is not supported by a wired infrastructure as conventional cellular systems are. Thus, it can be instantly deployed in areas with no infrastructure at all. By using a distributed clustering algorithm, nodes are organized into clusters. The clusterheads act as local coordinators to resolve channel scheduling, perform power measurement/control, maintain time division frame synchronization, and enhance the spatial reuse of time slots and codes. Moreover, to guarantee bandwidth for real time traffic, the architecture supports virtual circuits and allocates bandwidth to circuits at call setup time. The network is scalable to large numbers of nodes, and can handle mobility. Simulation experiments evaluate the performance of the proposed scheme in static and mobile environments.This work was supported by the U.S. Department of Justice/Federal Bureau of Investigation, ARPA/CSTO under Contract J-FBI-93-112 Computer Aided Design of High Performance Wireless Networked Systems.     

High-speed Modulation of InGaAs: Sb-GaAs-GaAsP quantum-well vertical-cavity surface-emitting lasers with 1.27-/spl mu/m emission wavelength

1.27-/spl mu/m InGaAs: Sb-GaAs-GaAsP vertical-cavity surface-emitting lasers (VCSELs) were grown by metal-organic chemical vapor deposition and exhibited excellent performance and temperature stability. The threshold current changes from 1.8 to 1.1 mA and the slope efficiency falls less than /spl sim/35% as the temperature raised from room temperature to 70/spl deg/C. With a bias current of only 5 mA, the 3-dB modulation frequency response was measured to be 8.36 GHz, which is appropriate for 10-Gb/s operation. The maximal bandwidth is measured to be 10.7 GHz with modulation current efficiency factor (MCEF) of /spl sim/5.25 GHz/(mA)/sup 1/2/. These VCSELs also demonstrate high-speed modulation up to 10 Gb/s from 25/spl deg/C to 70/spl deg/C.     

Importance of the Arg-Gly-Asp triplet in human thrombin for maintenance of structure and function

Site-directed mutagenesis was employed to assess the importance of the Arg-Gly-Asp triplet that comprises residues 197 to 199 in the B-chain of thrombin. Properties of the R197E and the D199E variants were compared with those of zeta-thrombin and the inactive S205A variant wherein the active site Ser is replaced by Ala. Relative to zeta-thrombin, the R197E thrombin variant under the assay conditions used exhibits 26% activity toward a small chromogenic substrate, 13% activity in the activation of protein C in the presence of thrombomodulin, < 3% activity in processing fibrinogen, and 1% activity in inducing platelet activation. Thus, the substrate specificity of thrombin was altered by the R197-->E replacement. The D199E variant was essentially inactive. It exhibited only 0.02% of the activity of thrombin toward the chromogenic substrate and its reactivity toward the active site-directed alkylating agent D-Phe-Pro-Arg-CH2Cl was 10,000-fold lower than that of thrombin. Like the inactive S205A thrombin variant, the D199E variant antagonized the interactions of thrombin with hirudin and thrombomodulin, but was a less effective antagonist. The dependence of the antagonism of the thrombin-thrombomodulin interaction on the concentration of D199E thrombin variant provided evidence suggesting the presence of two or more domains in thrombin that independently interact with their counterparts in thrombomodulin. Although the S205A thrombin variant antagonized the action of thrombin on platelets no such activity could be demonstrated for the D199E variant in the concentration range studied (< 800 nm). Comparison of the circular dichroism spectra of zeta-thrombin, the D199E, R197E, and S205A variants indicated that subtle differences in conformation exist between the D199E variant and the other thrombins. These differences in conformation might well account for the altered behavior of the D199E variant with respect to its interactions toward thrombomodulin, hirudin, and platelets.